Supplies required for making the string bracelet:
- Golden Spacer Bead
- Crimp Bead
- Lobster Claw Clasp
- 0.5mm Tiger Tail Wire
- 1mm Nylon Thread
- Flat Nose Plier
Step1: Make the spacer bead strand
1st, cut a 50cm long wire and connect a crimp bead at 5cm in the end;
2nd, slide the spacer bead one after one;
3rd, stop once the beads strand almost twice the duration of your wrist circumference;
4th, attach another crimp bead at end to stop beads from dropping and adjusting the tightness among beads on wire.
Step2: Wrap around the string
1st, cut an overall length of 1mm nylon thread, measuring about 100cm;
2nd, fold it in two;
3rd, fold you beaded strand as picture shows and loop the thread across the area between first two beads. Bring one end exceeding the beaded strand and the other one going under;
4th, twist two ends together to turn the cord in other direction. Angling down to the next gap and repeat the process above;
5th, continue crossing over and filling in the gaps;
6th, eliminate the two crimp beads at ends and tie both ends of tiger tail wire;
7th, secure two thread end having a tight knot. Be sure and then trim off any excess thread.
Wire Wrap Jewelry
Step3: Attach the clasp
Open the jumprings and fix the clasp at end!
So, there you’ve your new string bracelet!